A-A-55210A
(A) With slide fastener closed and waistband hooked, measure along top edge of waistband from
folded edge. Multiply by two (2).
(B) With slide fastener closed and waistband hooked, measure from edge to folded edge, one inch
above fly bartack. Multiply by two (2).
(C) Measure along inseam from crotch seam to (unhemmed) bottom edge of leg.
(D) Twice the measurement from folded edge to folded edge across the width of slack leg at a point up
from bottom of leg as follows:
Short - 16 inches
Long - 18 inches
Regular - 17 inches
X-Long - 19 inches
(E) Measure across unhemmed bottom edge of leg. Multiply by two (2).
3.6 Patterns. The Government will furnish a set of standard patterns to be used to cut working
patterns. The working patterns shall be identical to the Government patterns. Neither the
Government patterns nor the working patterns shall be altered in any way, except that additional
notches for use during construction are allowed on working patterns. Also, minor
modifications are permitted where necessary when using automatic equipment. These modifications
shall not alter the dimensional, serviceability, or appearance requirements. The
standard patterns provide a seam allowance of 5/16 inch for all seams except for 1/2 inch allowance for
the inseams and outseams. In addition, the back seam allowance shall be 7/8 inches at the top tapered
to 1/2 inch at the crotch.
3.6.1 Pattern Parts. The component parts shall be cut from the materials specified in accordance with
the following pattern parts:
Material
Pattern part
Cut parts
Basic material
Front
2
Back
2
Waistband
2
Side pocket bearer
2
Side pocket facing
2
Hip pocket bearer
2
Hip pocket narrow facing
2
Left fly
1
Right fly facing
1
Right fly interlining
1
Pocketing/lining
Side pocket
2
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business