MIL-DTL-29397B(MC)
be removed and rinsed in warm, then cold, then hot water, after
which they shall be wiped gently in an absorbent cellulose
material or whirled to remove residual moisture, and allowed to
air dry at room temperature for a period of one hour. There
shall be no change in the appearance of the lacquered surfaces
except for a slight overall yellowing and not more than three
dark spots, each not exceeding 1/32 inch largest dimension.
4.5.1.2. Tackiness. At room temperature (60° to 80°F) press a
piece of tissue paper against the lacquered surface for 30
seconds, using any pressure capable of being exerted by the thumb
and two fingers. The tissue shall not adhere to the lacquered
surface, but shall fall free when pressure is released.
4.5.2 Weight of braid per gross yards. Weigh six yards of braid
in a relaxed condition on a balance or scale accurate to ± 0.25
percent. Convert to ounces and multiply by 24 to obtain the
weight of 144 yards.
5.
PACKAGING
5.1. Packaging. For acquisition purposes, the packaging
requirements shall be as specified in the contract or order (see
6.2). When actual packaging of material is to be performed by
Department of Defense (DoD) personnel, these personnel need to
contact the responsible packaging activity to ascertain requisite
packaging requirements. Packaging requirements are maintained by
the Inventory Control Point's packaging activity within the
Military Department of Defense Agency, or within the Military
Department's Systems Command. Packaging data retrieval is
available from the managing Military Department's or Defense
Agency's automated packaging files, CD-ROM products, or by
contacting the responsible packaging activity.
6.
NOTES
(This section contains information of a general or
explanatory nature that may be helpful, but is not mandatory.)
6.1. Intended use. The coats described herein are intended for
wear by enlisted female personnel of the U.S. Marine Corps Band.
6.2. Acquisition requirements.
Acquisition documents must
specify the following:
71
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business