MIL-DTL-29477A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
Make front.
5
(cont'd)
d. As an option, a and b above the
front knitted panel and the lower
front panel may be joined in one
continuous operation.
6
Make back.
Finished appearance. The back parts
shall be joined without gathers,
puckers or pleats.
a. Position the back panels face to
301
SSa-1
10-14
50
50
face with edges even and join at the
or
center with a 5/8 inch seam. The
401
ends of the seam shall finish evenly.
b. Spread open center back seam and
press smooth and flat with a heated
iron or pressing machine.
7
Make back darts.
Finished appearance. The darts shall
be tapered on the inside without
twists or puckers. Thread ends at
lower end of darts shall not be
trimmed closer than 1/2 inch in
length. End of darts need not be
bartacked.
a. Fold and stitch back waist darts
301
OSf-1
10-14
50
50
in accordance with marks and notches
or
50
70
as indicated on the pattern. The
401
lower ends of the waist darts shall
be tapered.
b. Press the darts smooth and flat
with a heated pressing iron, with the
inside folded edge of darts toward
the center back seam.
8
Join lining back parts.
Finished appearance. The lining back
part shall be joined without gathers,
puckers or pleats.
a. Position the lining back parts
301
SSa-1
10-14
50
50
face to face with edges even and join
at the center with a 3/4 inch seam,
from bottom of skirt to top of
waistband.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business