MIL-DTL-29394C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
Join lining back parts.
9
Finished appearance. The lining back
parts shall be joined without
gathers, puckers or pleats.
a. Position the lining back parts
301
SSa-1
10-14
50
50
face to face with edges even and join
at the center with a 3/4 inch seam,
from bottom of skirt to 7-1/2 inches
from top raw edge to provide for
center opening.
b. The center opening shall be edge
301
EFb-1
12-14
50
50
stitched 1/8 inch on each side.
10 Join lining front parts.
a. Position the lining front parts
301
SSa-1
10-14
50
50
face to face with edges even and join
at the center with a 3/4 inch seam.
11 Join front and back parts of lining.
a. Join the front and back parts of
301
SSa-1
10-12
50
50
lining at the side seam with a 3/4
inch seam and with notches matching.
Spread open the center back seam and
side seams and press smooth and flat
with a heated iron or pressing
machine.
12 Make waistband.
Finished appearance. On the finished
skirt, the outside end of the
waistband shall be pointed and the
inside end shall be squared.
a. The waistband shall be made of a
single ply of basic material and a
single ply of interlining (twill or
fusible).
b. Position the interlining on the
301
SSa-1
10-14
A
A
inside of waistband with bottom edges
even. Stitch the interlining to the
underside of waistband along the top
and bottom edges of interlining with
a 1/8 inch seam. The line of
stitching shall extend the entire
length of waistband but the stitching
shall not show on the front of the
waistband.
-or-
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business