MIL-DTL-29397B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
Cutting.
1
(cont'd)
h. Cut the cotton buckram for
interlining the collar on the
straight in accordance with the
pattern furnished.
i. Cut the piping material (see
3.3.4) for piping the front and
bottom edges of jackets, lower edge
and end of collar and top edge of
ornamental sleeve cuffs on the
straight. The piping shall be cut
5/8 to 3/4 inch wide for collar and
ornamental sleeve cuffs, and 1-1/4
inch wide for bottom and front edges
of jacket.
Replacement of damaged parts.
2
a. Replace at time of cutting any
part of jacket containing holes,
seriously weakening defects such as
smashes, multiple floats, loose or
weakening slubs, expected to develop
into holes, shade bars and dye
streaks or unsightly slubs, etc.,
affecting appearance.
b. Replace any part damaged during
the manufacturing process by needle
chews which may develop into holes,
scissor or knife cuts, tears, holes,
mends or burns in the material,
affecting appearance.
3
Shade marking.
a. Mark or ticket all component
parts (see 3.6.2) cut from one piece
of the basic material. Mark or
ticket all component parts cut from
one piece of rayon lining material
and the pairs of sleeve linings when
cut from ends.
b. The use of tickets with any metal
fastening devices is prohibited on
the rayon lining.
4
Make shoulder loops.
Finished appearance. The finished
loops shall be uniform in width and
shall finish 5/8 ± 1/8 inches wide.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business