MIL-DTL-29397B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
8
Make underarm shields.
Finished appearance. The underarm
shields shall finish smooth and flat
without puckers, pleats, gathers or
other distortions.
a. Bind the rounded edge of shield
301
BSb-1
10-14
A
A
with bias binding, turning under the
outside edge of the binding only and
catching the turned under portion in
the stitching 1/16 inch from the
folded edge.
b. Press the shields smooth and flat
with a heated pressing iron or
pressing machine.
9
Make cuffs and eyelet opening.
Finished appearance. The cuffs shall
be uniform in appearance, shall
finish smooth and flat, without
twists, gathers, pleats, puckers or
other distortions. The cuffs shall
finish 5 inches high at the point on
top sleeve and 3 inches high at the
backarm, including piping. The
piping shall extend uniformly 1/8
inch beyond the seamed edges of the
sleeve cuff.
a. The cuffs shall be made of one
ply of material specified in 3.3.2
piped with material specified in
3.3.4.
b. Position one ply of the cuff
301
LSq-2
10-14
A
A
eyelet facing on the outside of
(a)
sleeve cuff, face to face, with back
edges even and notches matching.
Join the two plies together from
notch to notch with 3/8 inch seam.
c. Extend the depth of the notches
301
LSq-3
10-14
A
A
to the seam line. Turn back the
(b)
facing and topstitch the facing to
the cuff 1/16 to 1/8 inch from the
raised edge.
d. Mark location for three eyelets
on each cuff for removable buttons.
e. Make 1/8 inch eyelet on each of
Eyelet
22 per
A
A
the marks through both plies.
eyelet
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business