MIL-DTL-29397B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
13 Baste and tack cuff to sleeve.
a. Turn the bottom of the cuff to
301
the inside against the bottom edge of
or
sleeve in accordance with notches,
Hand
and bast along the turned edge of the
cuff.
b. Tack the raw edge of cuff to the
301
EFe-1
4-6
A
A
body of sleeves with blind stitching.
The blind stitching shall not be
exposed on, or caught to, the outside
of the cuff.
13 Baste and tack cuff to sleeve.
(cont'd)
c. On the finished jacket, the
height of the cuff, when measured
from folded bottom edge of cuff,
shall be 3 ± 1/8 inches at the
forearm and backarm seams, and 5 ±
1/8 inches at the point.
14 Seam sleeve lining at forearm.
Finished appearance. The forearm
seam shall finish smooth and flat
without puckers, twists, gathers or
pleats and shall start and finish
evenly.
a. Position the top sleeve lining
301
SSbd-1
12-16
A
A
with upper forearm edge in line with
or
the notch in the armhole edge of
SSa-1
under sleeve lining and with the
notches in lower forearm edge of top
and under sleeve linings matching.
Seam the top and under sleeve lining
together 3/8 inch from the forearm
edge of top sleeve lining, forming a
tapered outlet on the under sleeve
lining.
15 Seam sleeve lining at backarm.
Finished appearance. The backarm
shall finish smooth and flat, without
twists, gathers, puckers or pleats
and shall start and finish evenly.
a. Join the top and under sleeve
301
SSa-1
10-14
A
A
linings at the backarm with a 3/8
inch seam.
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business