MIL-DTL-29397B(MC)
4/
Sleeve length measurement taken along forearm seam from pit
of armhole to bottom edge of sleeve.
5/
Collar sizes represent length of collar in inches measured
from end to end along the center.
3.8. Workmanship. The finished jacket shall conform to the
quality and grade of product established by this specification.
3.9. Recycled, recovered, or environmentally preferable
materials. Recycled, recovered, or environmentally preferable
materials should be used to the maximum extent possible provided
that the material meets or exceeds the operational and
maintenance requirements, and promotes economically advantageous
life cycle costs.
4.
VERIFICATION
4.1. Classification of inspection. The inspection requirements
specified herein are classified as follows:
a.
First article inspection (see 4.3).
b.
Conformance inspection (see 4.4).
4.2. Inspection conditions. Unless otherwise specified, all
inspections shall be performed in accordance with the provisions
set forth in ANSI/ASQC Z1.4.
4.3. First article inspection. When first article is required,
inspection shall be made of a completely fabricated jacket for
all provisions of this specification.
4.4. Conformance inspection.
4.4.1 Testing of components. Testing of components shall be in
accordance with the applicable subsidiary specifications and
standards to the extend applicable, except that this
specification shall govern in the event of conflict. The method
of testing shall be as specified in FED-STD-191, wherever
applicable. Testing shall be performed on components listed in
Table III for characteristics noted.
4.4.1.1. Sampling for testing. Unless otherwise specified in
subsidiary specifications, sampling shall be in accordance with
47
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business