MIL-DTL-29397B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
63 Set sleeves.
Finished appearance. The armhole-
sleeve seam shall finish without
twists, gathers, puckers or pleats.
a. Position sleeves on outside of
jacket at the armholes, with the back
notch matching the side back seam,
and with notch in top sleeve and
front matching.
b. Join the sleeve to the jacket
301
SSa-1
10-14
A
A
with a 3/8 inch seam, distributing
the fullness in accordance with good
manufacturing practice.
c. Press the entire armhole smooth
and flat with a heated pressing iron
to remove fullness, exercising care
not to stretch the armhole.
64 Baste armhole.
a. Baste around the entire armhole
Hand
on the inside, holding the back
or
lining, shoulder pad and front lining
301
Hopper
in place and distributing fullness
evenly. Turn jacket on the outside.
b. Baste around outside armhole
Hand
adjacent to the armhole seam, forcing
or
out the armhole in the basting. The
301
Hopper
basting shall extend from the backarm
seam of sleeves to the front notch of
jacket.
65 Set underarm shields to jacket.
a. Position the underarm shield on
the lining side of jacket with the
raw edges even with lower edge of
armhole.
b. Baste the underarm shields to the
Hand
jacket along the vertical center and
or
top, side and bottom edges.
301
Hopper
66 Stitch sleeve-head pads and linings
at armhole.
Finished appearance. The armhole
shall not be distorted or puckered
due to stitching the sleeve-head pads
and linings at the armhole.
40
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business