MIL-DTL-82122D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE STCH/IN
NDL
LPR
Assemble ornamental top collar and
7
under collar. (cont'd)
e. Trim and turn the side edges
Hand
(ends) or ornamental top collar 3/8
inch over the interlining between the
under collar and the interlining.
Baste the edges, forming the points
at the top (outer) corners of the
collar.
f. Fell the top (outer) and side
Hand
8-10
C
edges (ends) of under collar to the
(silk)
ornamental top collar, from end of
zig-zag stitching, around pointed
corners, and along the side edges
(ends).
g. Press the collar smooth and flat
with a heated pressing machine.
h. Trim the lower edge of the
ornamental top collar to provide for
seaming to jacket. Cut a guide notch
in the lower (neck) edge of top
collar at the center. Press and
crease collarstand at breakline to
approximately 2 inches from the neck
edge at each end.
i. Make one eyelet at each end of
Eyelet
20 per
A
A
collar, with edge of eyelet opening 1
eyelet
(silk)
inch from the top (outer) and side
(min.)
(scarlet)
edges (ends). The eyelets shall be
well worked with the purling on the
outside of the collar.
8
Seam sleeves at forearm.
Finished appearance. The forearm
seam shall finish smooth and flat
without twists, gathers, puckers, or
pleats and shall start and finish
evenly.
a. Position the top sleeve with
upper forearm edge in line with notch
at the armhole edge of under sleeve,
and with notches at the lower forearm
edge of top and under sleeve matching
and the edges even.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business