MIL-DTL-82122D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE STCH/IN
NDL
LPR
15 Make underarm shields.
(cont'd)
b. Seam the two pieces together 1/4
301
SSa-1
10-14
A
A
inch from the raw edge, along the
outward curved edge. Turn shield,
working out the seamed edges.
c. Press the shields smooth and flat
with a heated pressing iron or
pressing machine.
16 Stitch bust darts in front lining.
Finished appearance. The underarm
bust dart shall be tapered to a point
at front end and shall finish without
gathers, puckers, or pleats.
a. Fold the front lining with the
301
SSa-1
10-14
A
A
cut edge of the underarm bust dart
even. Stitch the entire length of
dart 1/4 inch from the cut edges at
the back end, tapering to a point
approximately 1/2 inch forward of the
front end of the cut. Securely
backtack the pointed end.
17 Make inside pocket.
Finished appearance. the pocket
shall be uniformly stitched and
finish smooth and flat without
causing distortion.
a. The pocket shall be made of
two-ply polyester/cotton material.
(5" wide X 6 1/2" long)
b. Position both plies of pocketing
301
SSa-1
10-14
A
A
material face to face with notches
matching and stitch together or form
the top notch across the top, back,
bottom and up the front to the bottom
notch with a 3/8 inch seam, leaving a
4 1/2 inch opening for the pocket.
c. Attach the front pocket openings
301
SSa-1
10-14
A
to the right front facing and the
right front lining respectively with
a 3/8 inch seam leaving a 4 1/2 inch
opening that starts approximately 3
inches ± 1/2 inch above the bottom
hem of the jacket.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business