MIL-DTL-82122D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE STCH/IN
NDL
LPR
17 Make inside pocket.
(cont'd)
d. Raise stitch the pocket material
301
SSc-1
10-14
A
A
onto the facing and lining
respectively with a 1/16 inch
topstitch.
18 Seam wool facing to front lining; sew
on label.
Finished appearance. The lining
shall be seamed to the facing so that
in the finished jacket, the lining
shall be smooth and flat along the
facing without creases, bulges, over
lapping of excess material, or other
defect or distortion.
a. Position the lining on the wool
301
SSa-1
10-14
A
A
facing with notches matching and seam
the front edge of the lining to the
back edge of the facing, 3/8 inch
from the edge. The stitching shall
extend from the top edge of the
facing to approximately 1-1/4 inches
from the bottom edge.
b. Sew the identification label to
301
SSa-1
10-14
A
A
the left front lining, as worn, with
(each
a single row of stitching 1/16 inch
edge)
from each edge of the label. The
label shall be positioned with the
right end even with the facing-lining
seam and the lower edge approximately
3 inches above the bottom edge of the
jacket.
19 Assemble body lining.
Finished appearance. The front, side
back, and back lining shall be
uniformly stitched. The lining shall
finish smooth and flat without
twists, gathers, puckers, pleats, or
raw edges. Seams shall start and
finish evenly at the line of
stitching.
a. Position and join the left and
301
SSa-1
10-14
A
A
right side back linings to the
corresponding edge of the center back
lining with a 3/8 inch seam and with
notches matching.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business