MIL-DTL-29384B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
17
Join back to front.
Finished appearance. The seams
shall be carefully joined without
twists, puckers or pleats. The
seams shall start and finish
evenly. The back shall be over the
fronts. The lower joining seam for
the two-ply back shall not be
visible on the outside of the vest.
a. Position right and left fronts
between the plies of the respective
two-ply backs and with edges even,
notches matching and lower edge of
front abutting the lower joining
seam for the two-ply back.
b. Join the back to the fronts
301
SSa-1
10-14
40/3
40/3
along the sides, through all plies,
with a row of stitches in line with
the upper and lower notches forming
an outlet at the side seams. Close
the two-ply back at the armhole
with a 3/8 inch seam.
c. Notch the seam allowance around
armholes for better turning.
d. Join the back to the front at
301
SSa-1
10-14
A
A
the shoulder with a 3/8 inch seam.
The seam shall extend from the
armhole seam to approximately 3/8
to 1/2 inch from the upper raw edge
of the back lining.
e. Pull fronts through the neck
Hand
8-10
C
opening. Turn under the raw top
(silk)
edges of the back lining
approximately 3/8 inch and fell the
folded edges to the respective neck
extension of front and front
facing.
18
Make buttonholes.
Finished appearance. The
buttonholes shall be clean-cut,
well made and correctly positioned.
The stitching shall be securely
caught in the fabric.
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business