MIL-DTL-29384B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
10
Stitch lining, for eyelet opening,
to facing. (cont'd)
c. Stitch the front raw edge of
301
SSa-1
10-14
A
A
lining and facing together 1/8 to
(silk) (silk)
3/16 inch from the raw edge. Trim
excess lining if necessary.
11
Assemble front lining.
a. Fold the side front lining,
301
SSa-1
10-14
A
A
matching the cut edges of the bust
dart, and stitch the entire length
1/4 inch from the cut edge at the
back end and tapering to a point at
the front end.
b. Position front lining and side
301
SSa-1
10-14
A
A
front lining back to back with
notches matching and join together
with a 3/8 inch seam.
12
Seam facing to front lining.
Finished appearance. The lining
shall be properly and carefully
aligned and seamed to the facing so
that in the finished vest, the
lining shall be smooth and flat
along the facing without creases,
bulges, overlapping of excess
material, or other defect or
distortion. The eyelet opening
shall not gap or be distorted.
a. Position right and left front
linings on the respective facing
with the notches at back edge of
facing and front edge of lining
matching.
b. Join lining to the left front
301
SSa-1
10-14
A
A
facing with a 3/8 inch seam,
extending from the notch at the
upper edge of facing to top notch
for the eyelet opening and from the
bottom notch for the eyelet opening
to the lower edge of facing.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business