MIL-DTL-29384B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
12
Seam facing to front lining.
(cont'd)
c. Form a 3/16 to 1/4 inch hem in
301
EFb-1
10-14
A
A
the lining, from top to bottom
eyelet opening notches, turning
under the raw edge and catching the
turned under edge in the stitching
1/16 inch from the inner folded
edge of the hem.
d. Tack both ends of the eyelet
301
10-14
A
A
opening.
e. Join lining to right front
301
SSa-1
10-14
A
A
facing from the notch at the upper
edge to the lower edge of the
facing.
f. Press the facing-lining seam,
front side joining seams and bust
darts smooth and flat. The bust
dart shall be pressed toward the
armhole and the facing-lining seam
and front side seam shall be
pressed toward the back.
13
Join back and waist darts.
Finished appearance. The back
seams shall start and finish evenly
and shall be smooth and flat
without gathers, puckers or pleats.
a. The back, cut from rayon
material, shall be two-ply and each
ply shall consist of a right and
left part.
b. Properly position the right and
301
SSa-1
10-14
A
A
left parts of each ply with edges
even. Join the right and left
parts of each ply together with a
3/8 inch seam along the center
back.
c. Fold the darts, matching the
301
SSa-1
10-14
A
A
cut edges. Stitch along the entire
length of the darts, beginning 3/8
inch from the raw edge at the
bottom end and tapering to a point
at the top end.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business