MIL-DTL-29384B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
18
(cont'd)
Make buttonholes.
a. Mark the right front in
accordance with the marks on the
pattern for the location of four
buttonholes.
b. Make a horizontal, eyelet end,
Button
60 per
A
A
button
square-bar type buttonhole, cut 5/8
- hole
inch, at each of the marks on the
-
right front. The inside edge of
hole
(min)
the buttonhole eyelet shall finish
3/8 to 1/2 inch from the front
edge.
c. The buttonholes shall be well
worked over gimp to fit the 22-line
button. The gimp shall be pulled
through to the underside. The
purling shall be on the outside.
d. Securely bartack the end of
Bartac
21 per
40/3
40/3
each buttonhole and trim the ends
k
of the gimp.
bartac
k
(min)
19
Attach buttons (when required).
Finished appearance. The buttons
shall be properly attached to the
vest. The buttons shall be
properly aligned with the
buttonholes to secure a smooth and
complete closure without bulging or
misalignment.
a. Attach four 22-line insignia
buttons to the left front with
shank of buttons inserted through
eyelets and secured by ring
fasteners.
20
Clean vest.
a. Trim all ends of stitchings and
remove all loose threads from the
vest.
b. Remove all spots, shade
tickets, markers and stains from
the vest without injury to the
material.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business