MIL-DTL-29384B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
3
Shade marking.
a. Mark all component parts cut
from one piece of basic and lining
materials to insure uniform shade
and size throughout the vest.
b. The use of tickets with metal
fastening devices is prohibited on
the rayon material.
c. Adhesive type shade ticket,
when used, shall be adhered to the
inside of the vest.
4
Labeling.
Finished appearance. The labels
shall be correctly positioned and
securely attached.
a. Position the identification
301
LSbj-1
12-14
A
A
label in front lining approximately
1 inch from the finished side seam
and approximately 4 inches from
armhole and seam on all sides 1/8
inch from each edge.
b. The size label shall be
301
LSbj-1
12-14
A
A
centered on the inside right back
1-1/2 to 2 inches below the neck
and seamed 1/8 inch from all edges.
5
Make fronts.
a. Position the left and right
front interlining on the underside
of their respective vest fronts and
fuse (see 3.6.3).
b. Position the left and right
side front interlining on the
underside of their respective side
fronts and fuse (see 3.6.3).
c. Position facing rayon lining on
301
SSa-1
10-14
A
A
the inside of left front with front
and bottom edges even. Stitch the
two piles together 1/8 inch from
bottom and front edge.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business