MIL-DTL-29384B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
Join back and waist darts.
13
(cont'd)
d. Position the back component
301
SSa-1
10-14
40/3
40/3
face to face, with edges even and
center seams matching and join
together along the bottom edge with
a 3/8 inch seam.
e. Turn the two-ply back face side
out and press the seam smooth and
flat with a heated pressing iron or
pressing machine. The bottom seam
shall not be visible on the
outside.
Join facing-lining assemblies to
14
front with tapes.
Finished appearance. The
facing-lining assemblies shall be
joined to the fronts in such a way
as to produce smooth and flat seams
without pleats, puckers or gathers
in the finished vest.
a. Position facing-lining assembly
on the outside of the respective
fronts, with the upper edge of neck
extension and front edges even.
b. Join facing-lining assemblies
301
SSab-1
10-14
A
A
to the front with a 1/4 inch seam
and with the stray tape positioned
on the inside of the front 1/8 inch
from the edge and caught in the
stitching. The line of stitching
shall extend from within 1 inch of
the ends of the neck extension,
along the front and bottom edge to
the side edge.
c. Join the lining to the fronts
301
SSa-1
10-14
A
A
along the armhole with a 3/8 inch
seam.
15
Join neck.
a. Position right and left fronts
301
SSa-1
10-14
A
A
face to face and with raw end of
neck extension even. Join the neck
extensions with a seem 3/8 inch
from the raw ends.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business