MIL-DTL-29478A(MC)
2/
Breast measurement taken with coat buttoned, from folded
edge to folded edge in line with pit of armhole; multiply by
2.
3/
Back length measurement taken along center from lower back
peak of collar to bottom edge of coat.
4/
Sleeve length measurement taken along forearm seam from pit
of armhole to bottom edge of sleeve.
5/
Collar sizes represent length of collar in inches measured
from end to end along the center.
NOTE:
Measurements for special measurement items will be as
recorded on special measurement forms.
3.8. Workmanship. The finished coats shall conform to the
quality and grade of product established by this specification.
3.9. Recycled, recovered, or environmentally preferable
materials. Recycled, recovered, or environmentally preferable
materials should be used to the maximum extent possible provided
that the material meets or exceeds the operational and
maintenance requirements, and promotes economically advantageous
life cycle costs.
4.
VERIFICATION
4.1. Classification of inspection. The inspection requirements
specified herein are classified as follows:
a.
First article inspection (see 4.3).
b.
Conformance inspection (see 4.4).
4.2. Inspection conditions. Unless otherwise specified, all
inspections shall be performed in accordance with the provisions
set forth in ANSI/ASQC Z1.4.
4.3. First article inspection. When first article is required,
inspection shall be made of a completely fabricated jacket for
all provisions of this specification.
4.4. Conformance inspection.
48
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business