MIL-DTL-29478A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
63 Set collar with lining.
(cont'd)
a. Mark the neckline on the outside
3/8 inch from the collar notch up to
the shoulder seam and gradually to
within 1-1/4 to 1-3/8 inches at the
center back for position of collar.
b. Position the collar with the
lower edge lapped on the outside top
edges of the coat at the mark.
c. Seam the collar from end to end,
301
LSa-1
10-14
A
A
to the coat, as close as possible to,
(silk)
(silk)
but not on top of, the stitching for
the piping at the lower edge of the
collar. The stitching shall not be
through the collar lining.
64 Set sleeves.
Finished appearance. The
armhole-sleeve seam shall finish
without twists, gathers, pleats or
puckers.
a. Position sleeves on outside of
coat at the armholes, with the back
notch matching the side back seam,
and with notch in top sleeve and
front matching.
b. Join the sleeve to the coat with
301
SSa-1
10-14
A
A
a 3/8 inch seam, distributing the
fullness in accordance with good
manufacturing practice.
c. Press the entire armhole smooth
and flat with a heated pressing iron
to remove fullness, exercising care
not to stretch the armhole.
65 Baste armhole.
a. Baste around the entire armhole
Hand
on the inside, holding the back
or
lining, shoulder pad and front lining
301
Hopper
in place and distributing fullness
evenly. Turn coat on the outside.
41
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business