MIL-DTL-29478A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
60 Baste shoulder.
a. Position the front lining and
Hand
coat front interlining at the neck,
or
shoulder and armhole edges of the
301
Hopper
fronts. Baste all plies together on
the outside along the front edge of
armhole and continue along the
shoulder seam and the gorge, catching
the shoulder pad in the basting.
Turn the coat on the inside.
61 Baste back lining and facing-lining
assembly at shoulders.
a. Turn under and lap the shoulder
Hand
edge of the back lining on the
facing-lining assembly. Baste lining
along the folded edge of the back
lining with the top end of the chest
pleat caught in the basting.
62 Seam neckline with size label and
coat hanger.
Finished appearance. The neckline
shall finish smooth and flat, without
twists, pleats, or puckers. The size
label shall be positioned between the
ends of the coat hanger and the ends
of the coat hanger shall be
positioned so that in the finished
coat, the hanger opening shall be 2 +
1/8 inches long when measured along
the lower edge of collar lining.
a. Join facings and back lining to
301
SSa-1
10-14
A
A
coat at the neckline from collar
notch to collar notch, with a 1/4
inch seam and with the upper edge of
the size label and the ends of the
hanger positioned and caught in the
stitching at the inside center back.
b. Press the neckline of the coat
smooth and flat with a heated
pressing iron or pressing machine.
63 Set collar with lining.
Finished appearance. The collar
shall be carefully joined to the coat
without distortion of the collar.
40
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business