MIL-DTL-29478A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
65 Baste armhole.
(cont'd)
b. Baste around outside armhole
Hand
adjacent to the armhole seam, forcing
or
out the armhole in the basting. The
301
Hopper
basting shall extend from the backarm
seam of sleeves to the front notch of
coat.
66 Set underarm shields to coat.
a. Position the underarm shield on
Hand
the lining side of coat with the raw
or
edges even with lower edge of
301
Hopper
armhole.
b. Baste the underarm shields to the
Hand
coat along the vertical center and
or
top, side, and bottom edges.
301
Hopper
67 Stitch sleeve-head pads and linings
at armhole.
Finished appearance. The armhole
shall not be distorted or puckered
due to stitching the sleeve-head pads
and linings at the armhole.
a. Position the sleeve-head pad on
the sleeve with the folded edge of
the pad approximately 1/8 inch back
from the raw edge of the
armhole-sleeve seam, and the one end
of the pad matching the notch in the
front.
b. Stitch the sleeve-head pad to the
301
SSa-1
4-6
24/4
24/4
sleeve from end to end, through the
armhole-sleeve seam allowance, 1/8
inch from the folded edge of the pad,
catching the front and back linings
and the shoulder pad in the
stitching. Continue stitching the
linings around the remainder of the
armhole, catching the underarm
shields in the stitching and trimming
away the excess material.
c. The underarm shield may be basted
to the armhole prior to stitching.
42
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business