MIL-DTL-29395B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
(cont'd)
e. Cut the crotch lining and pockets
from the twill cloth in accordance
with the patterns.
f. Cut the ornamental stripes in the
warp direction. Cut two white
stripes 1-1/4 inches wide and four
scarlet stripes 1 inch wide.
Shade marking.
2
a. Mark or ticket all component
parts of slacks except parts cut from
ends, to ensure a correct size and
uniform shade throughout the slacks
(or uniform).
b. The use of corrosive metal
fastening devices or sew-on tickets
for shade marking is prohibited.
c. The use of ink pad numbering
machine, rubber stamp, or pencil is
acceptable provided the numbers do
not show on the outside of the slacks
and whenever possible, numbers shall
be covered by the seam allowance.
3
Replacement of defective components.
a. During the spreading, cutting and
manufacturing process, components
having material defects or damages
that are classified as defects in
MIL-STD-656 shall be removed from
production and replaced with
nondefective and properly matched
components.
4
Make ornamental stripes.
Finished appearance. The ornamental
scarlet stripes shall be basted
without distortions and the finished
stripe shall be uniformly 1-1/8 to
1-1/4 inches wide.
a. The ornamental stripe shall be
made of two stripes of scarlet
material each cut 1 inch wide and one
stripe of white material cut 1-1/4
inches wide (see 3.3.4).
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business