MIL-DTL-29395B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
15 Make waistband.
(cont'd)
f. The edge stitching may be
performed continuously with the top
stitching on the outside of the
waistband in operation 19.a.
16 Join inseams.
a. Match notches at front and back
301
SSa-1
12-14
50/3
50/3
of inseam and join with a 1/2 inch
or
seam from notch to bottom.
401
50/3
50/3
b.
Press inseam open and flat.
17 Join crotch and seat seam.
Finished appearance. The crotch and
seat seams shall be joined with
stitch tension of sufficient
elasticity to meet strain encountered
in sitting and stooping. The waist
shall be measured before joining
crotch and seat seam to assure
correct waist size. In the finished
slacks, the inseams shall meet and
the right and left waistband joining
seams shall be aligned; the base of
the left fly shall cover the right
fly on the outside.
a. Measure waist to proper size
before joining crotch, seat and waist
seam.
b. Join crotch and seat seams from
401
SSa-1
8-10
AA
AA
the base of the fly to the notch with
(each
Poly-
Poly-
a 1/2 inch seam, tapering from the
needle)
ester
ester
notch through waistband to accomplish
the measured size and leaving a tail
of stitching 3/4 to 1 inch long.
c. Spread open crotch and seat seams
and press smooth and flat with a
heated pressing machine tucking in
the stitching tail under the pressed
open seat seam.
d. The inseam at the crotch shall
not stagger more than 3/16 inch.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business