MIL-DTL-29479A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH TYPE
BOB/
NO
OPERATION
TYPE
STCH/IN
NDL
LPR
a. Position the outside of the
fronts on the facing of the side
pocket in accordance with the notches
for the pocket openings as indicated
by marks on the pattern.
b. Seam front, facing and pocket
301
SSe-2
12-16
0
0
material together from notch to notch
(a)
3/8 inch from the edge of the front.
c. Cut the depth of the notches for
301
LSq-2
12-16
50/3
50/3
the pocket opening to the seam.
Raise stitch the joining seam on the
pocket facing and pocket 1/16 inch
from seam, catching all plies of the
seam.
d. Turn the pocket to the inside of
the front so that the seam will
finish on the inside of the pocket
1/16 inch back from the finished edge
of pocket opening.
e. Topstitch the front from notch to
301
SSe-2
12-16
A
A
notch through all plies of material,
(b)
or
or
1/4 inch from the finished edge of
(shows
50/3
50/3
the pocket opening.
finished
seam)
f. Fold pocket inside out and seam
301
SSae-2
12-16
A
A
raw edges from step to folded edge of
or
(a)
or
or
pocketing 3/16 to 1/4 inch from edge.
401
SSae-2
12-16
50/3
50/3
Notch pockets and bearers at top of
step and turn.
g. Tack the ends of pocket opening
301
SSa-1
12-16
A
A
to the facing with 1/4 to 3/8 inch
(each
or
or
tack. The right and left pocket
end)
50/3
50/3
opening shall not be out of alignment
by more than 1/2 inch.
11 Attach side pockets (1/8 top).
(cont'd)
h. In the finished slacks, the top
of pocket shall extend into the
waistband and be caught in the bottom
stitching of waistband.
i. The finished pocket opening
(after bartacking) shall measure
5-3/4 to 6-1/2 inches.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business