MIL-DTL-29479A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH TYPE
BOB/
NO
OPERATION
TYPE
STCH/IN
NDL
LPR
25 Make buttonhole.
Finished appearance. The buttonhole
shall be clean cut, well made and
correctly positioned. The stitching
shall be securely caught in the basic
material. The buttonhole shall be
well worked over gimp to fit a
27-line button. The purling of the
buttonhole shall be on the outside of
the waistband.
a. Make 3/4 inch long horizontal,
Button-
44-46
0
0
eyelet end, taper-bar type buttonhole
hole
per
through the center of the pointed end
of waistband with the inside, purled
button-
edge of the eyelet 1/2 to 5/8 inch
hole
from the finished ends to waistband.
(incl.
tack)
26 Clean slacks.
a. All ends of stitching shall be
trimmed and the loose threads removed
from slacks. Pull and remove any
basting threads.
b. Any spots, stains and shade
tickets or markings shall be removed
without injury to the material.
27 Sew on button.
a. Close the slide fastener and mark
or gage the outside ends of waistband
with the location for sewing on the
button to correspond with the eyelet
of buttonhole.
b. The button shall be positioned to
engage with the eyelet end of
buttonhole so that on the finished
slacks, the ends of the waistband lie
smooth and flat without twisting,
bulging, or other distortions.
20
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business