MIL-DTL-29479A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH TYPE
BOB/
NO
OPERATION
TYPE
STCH/IN
NDL
LPR
b. Position the eye at the center of
the right waistband aligned with
slide fastener scoops and to
correspond with hook and left
waistband. Attach eye to right
waistband through a suitable
reinforcement.
21 Topstitch waistband.
Finished appearance. The waistband
shall be sewn on smoothly and evenly
and shall have a flat appearance
throughout, without gathers, puckers,
pleats or other distortions either in
the waistband, front part or back
part, and shall be even in width
along the entire length. The
waistband shall be 1-3/8 ± 1/8 inches
wide.
a. Topstitch the waistband to the
301
BSr-2
12-14
50/3
50/3
slacks 1/16 inch from the lower
(a)
folded edge, catching the overedge
stitched portion of waistband in the
stitching, and with the stitching
extending the entire length of the
waistband.
22 Join crotch and seat seam.
Finished appearance. The crotch and
seat seams shall be joined with
stitch tension of sufficient
elasticity to meet strain encountered
in sitting and stooping. The waist
shall be measured before joining
crotch and seat seam to assure
correct waist size. In the finished
slacks, the inseams shall meet and
the right and left waistband joining
seams shall be aligned; the base of
the left fly shall cover the right
fly on the outside.
a. Measure waist to proper size
before joining crotch, seat and waist
seam.
b. Join crotch and seat seams from
401
SSa-1
8-10
AA
AA
the base of the fly to the notch with
(each
Poly-
Poly-
a 1/2 inch seam, tapering from the
needle)
ester
ester
notch through waistband to accomplish
the measured size and leaving a tail
of stitching 3/4 to 1 inch long.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business