MIL-DTL-82126D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
5
Make waistband.
Finished appearance. On the finished
skirt, the outside end of the
waistband shall be pointed and the
inside end shall be squared.
a. The waistband shall be made of a
single ply of basic material and a
single ply of interlining (twill or
fusible).
b. Position the interlining on the
301
SSa-1
10-14
A
A
inside of waistband with bottom edges
even. Stitch the interlining to the
underside of waistband along the top
and bottom edges of interlining with
a 1/8 inch seam. The line of
stitching shall extend the entire
length of waistband but the stitching
shall not show on the front of the
waistband.
-or-
When fusing the interlining to the
waistband, position the interlining
on the inside of waistband with
bottom edges even. Stay stitch is
not required.
c. Overedge stitch the inside raw
503
EFd-1
8-12
70
70
edge of waistband.
or
504
d. Fold the waistband in half
301
SSe-2
12-16
A
A
lengthwise face to face with notches
matching. Join the two plies
together, at the pointed end, with
3/16 inch seam, starting at the
folded edge.
e. Close the squared end by seaming
301
SSe-2
12-16
A
A
the two plies together 3/16 inch from
(a)
the bottom raw edges, starting
approximately midway between the
notches and the end of the waistband,
then seam straight across the width
of the waistband to close the end.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business