MIL-DTL-82126D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
20 Make buttonholes.
(cont'd)
a. Make a 3/4 inch long horizontal,
Button-
52-54
0/3
0/3
eyelet end, taper-bar type buttonhole
hole
per
through the center of the pointed and
squared ends of waistband with the
button-
inside purled edge of the eyelet 1/2
hole
to 5/8 inch from the finished ends to
(incl.
waistband.
tack)
21 Clean skirt.
a. All ends of stitching shall be
trimmed and the loose threads removed
from skirt. Pull and remove any
basting threads.
b. Any spots, stains and shade
tickets or markings shall be removed
without injury to the material.
22 Press skirt.
a. The entire skirt shall be pressed
smooth with a heated pressing iron or
steam pressing machine. Remove all
press marks, wrinkles, gloss marks,
impressions and creases.
23 Sew on buttons.
a. Close the slide fastener and mark
the inside and outside ends of
waistband with the location for
sewing on the buttons to correspond
with the eyelet of buttonholes.
b. The buttons shall be positioned
to engage with the eyelet end of
buttonholes, so that on the finished
skirt, the ends of the waistband lie
smooth and flat without twisting,
bulging, or other distortion.
c. Securely sew a 27-line button at
Hand
4-6
16/4
each mark. The thread ends of hand
or
sewn buttons shall be securely
101
button-
tacked. The button on the outside of
or
hole
waistband shall be sewn through all
301
(double
plies of waistband. The stitches for
thread)
the button sewn to the inside of the
14-16
waistband shall not be visible on the
outside.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business