MIL-DTL-82126D(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
(cont'd)
g. Cut waistband interlining of
polyester and cotton twill or fusible
material (see 3.3.10) in accordance
with pattern to reinforce the
underside of the waistband.
2
Replacement of damaged parts.
a. Replace at time of cutting any
part of the skirt containing holes or
seriously weakening defects such as
smashes, multiple floats, loose
weakening slubs, etc., expected to
develop into holes, shade bars and
dye streaks or unsightly slubs, etc.
b. Replace any part damaged during
manufacturing process by needle chews
which may develop into a hole,
scissor or knife cuts, tears, holes,
mends or burns in the material.
3
Shade marking.
a. Mark, ticket or bundle all
component parts (see 3.6.4) cut from
one piece of basic material, except
those parts cut from ends, to ensure
uniform shade and size throughout the
skirt. All lining parts shall be
marked, bundled or ticketed to ensure
uniform shade and size throughout the
garment.
4
Make watch pocket.
a. The watch pocket shall be
made of
one ply of basic material and
one ply
of polyester/cotton twill and
shall
finish not less than 4 inches
wide
and 4 inches deep.
b. Position both plies of watch
301
SSa-1
10-14
50
50
pocket face up and with sides and
bottom edges even. Join both plies
together 3/8 inch from raw edges, 1/2
inch down from top raw edges at each
side.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business