MIL-DTL-82126D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
12 Join skirt back and front at sides.
Finished appearance. The side seams
shall be carefully joined without
twists, puckers, or pleats. The
seams shall start and finish evenly.
The contour of the waist and hipline
shall be maintained in the seaming.
a. Join the front and back parts of
301
SSa-1
10-14
A
A
skirt at the side seams with a 1 inch
seam from bottom to top edge with
notches matching.
13 Overedge seams.
a. The raw edges of the seam
501
SSa-1
8-10
70
70
allowances on the front and back
or
parts shall be neatly overedge
503
stitched.
NOTE: Care shall be exercised during
the overedging operation to ensure
that no seam allowance is reduced by
more than 1/16 inch.
14 Press seams.
Finished appearance. The seams in
the skirt and the lining shall be
well pressed without distortion of
the seams or the side openings.
a. Spread open all seams and press
smooth and flat with a heated
pressing iron or pressing machine.
The edges of the center back opening
of the skirt shall be folded back
straight and even with the back seam
allowance, and the opening pressed
smooth and flat with the folded edges
of the opening well creased.
b. Both plies of the center back
301
SSa-1
12-16
A
A
seam shall be pressed to the wearers'
(silk)
(silk)
left and the center back pleat shall
fall left over right and shall be top
stitched across the top from the
center back seam for 2-1/2 inches
toward the edge of the inner pleat at
a slight downward angle.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business