MIL-DTL-82126D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
16 Join placket assembly to skirt (see
Figure 3). (cont'd)
d. Topstitch across the bottom end
301
SSv-1
12-16
A
A
of the opening through the slide
(silk)
(silk)
fastener tape and the placket with a
single row of stitches. The
stitching shall not pass the finished
stitching of each side opening.
17 Join lining to skirt.
Finished appearance. The lining
shall be joined to the skirt at the
waist. The seam shall be smooth,
flat and without distortion.
a. Position the lining over the
301
SSa-1
10-14
A
A
skirt with the top raw edges even and
side seams matching, and the left
front and back lining panels at the
center back opening turned under as
specified in operation 8.b. Stitch
the lining to skirt at the waist 1/4
inch from the raw edge.
18 Join waistband to skirt, with hangers
and labels.
a. Position the waistband on the
inside of the skirt, with notches at
the pointed end of waistband even
with the left side edge of skirt,
with the bottom raw edge of the
waistband even with the top raw waist
edge of skirt, and with the notches
at the square end of waistband
matching the back folded edge of
skirt.
b. Join the outside part of the
301
LSa-1
12-16
A
A
waistband to the skirt with a 3/8
inch seam, with the braid for the
hangers folded in half to form a loop
and with the ends of the loops placed
on the inside of the skirt.
c. The hangers shall be positioned
at the side seams. The size label
shall be at the back on either side
of the zipper opening.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business