MIL-DTL-82126D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
Sew lining darts.
7
Finished appearance. The lining
darts shall finish smooth and flat
without distortion.
a. Sew front and back lining darts
301
SSa-1
12-16
A
A
in accordance with notches and marks
provided on the patterns.
b. Join the back lining parts with a
301
SSa-1
12-16
A
A
1 inch seam from the bottom, up to
within 8 inches from top of waist to
allow for slide fastener opening.
8
Join back and front linings.
Finished appearance. The side seams
of the lining shall be carefully
joined without twists, puckers, or
pleats. The seams shall start and
finish evenly. The seam allowances
in the lining shall not be exposed on
the inside of the finished skirt.
The contour of the waist and hipline
shall be maintained in the seaming.
a. Position the back and front
301
SSa-1
10-14
A
A
linings with notches matching and
join together at the side with a 1
inch seam from the bottom to the top
edge.
b. The back opening shall be
folded
301
EFb-1
12-14
50
50
and edge stitched 1/8 inch on
each
side. Folded edges of lining
shall
be stitched under the placket
and
left side of zipper tape.
9
Pink seams and bottom edge of lining.
a. The raw edge of the seam
allowances and raw edges at the
bottom of the front and back lining
shall be neatly and evenly pinked
with the points of the pinking 1/8
inch in depth.
10 Make back panel darts, form center
back pleat and seam skirt panels.
Finished appearance. The seams and
darts shall start and finish evenly
without twists, puckers, pleats or
other distortions.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business