MIL-DTL-82126D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
10 Make back panel darts, form center
back pleat and seam skirt panels.
(cont'd)
a. Join the side fronts and center
301
SSa-1
12-16
A
A
front panels, with a 3/4 inch seam
with notches matching.
b. Join the center back seam with a
301
SSa-1
12-16
A
A
1/2 inch seam from the mark on the
pattern, approximately 17-18 inches
from bottom raw edge, to the bottom
of the center back zipper
(approximately 7-1/2 inches) from top
of waist.
c. From the mark on the pattern for
301
SSa-1
12-16
A
A
the center back pleat to the bottom
edge of skirt, seam the inside edges
of the left and right edges with a
5/8 inch tape.
d. Turn the tape to the inside of
301
EFm-1
12-16
A
A
fabric and blindstitch the unsewn
edge to the underside of pleat
opening and press flat.
e. Sew the back darts in accordance
301
SSa-1
12-16
50/3
50/3
with notches and marks provided on
patterns.
11 Attach watch pocket.
a. Position the top inside ply of
301
SSa-1
12-16
50/3
50/3
the polyester/cotton twill side of
pocket to the top raw edge of the
right front of skirt waistband. The
notch of the pocket shall be 1 inch
in from the side seam. Join the
pocket to the skirt waist with a 3/8
inch seam, from notch to notch,
forming a 4 inch wide opening at the
top of the waistseam. Turn the
pocket up and raise stitch, 1/16 inch
through twill and front of skirt
catching all plies.
b. Notch and turn pocket to the
Bartack
21-28
0
0
inside and bartack each edge of
per
opening.
bartack
NOTE: Watch pocket shall finish
between the basic fabric and the
lining.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business