MIL-DTL-29396B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
14 Assemble sleeve and sleeve lining.
Finished appearance. The lining
shall be seamed to the sleeve without
twists, gathers, puckers or pleats.
14 Assemble sleeve and sleeve lining.
(cont'd)
a. Position the sleeve lining on the
sleeve with upper edge of the lining
extending approximately 1 inch beyond
the armhole edge of the sleeve.
b. Tack the sleeve lining to the
301
4-6
A
A
forearm and backarm seam allowance,
or
respectively, of the sleeve,
Hand
1-2
commencing at the top edge of the
cuff and extending to approximately 6
inches from the armhole edge at
backarm and approximately 4-1/2
inches from armhole edge at forearm.
c. Turn sleeve lining over the
sleeve.
15 Fell sleeve lining turnup/press
sleeves.
Finished appearance. The sleeve
lining shall not be short, tight or
twisted at bottom of sleeves.
a. Turn under the bottom edge of the
101
sleeve lining to finish 1 to 1-1/4
or
inches above the finished end of
Hand
sleeve, and baste to turnup of cuffs,
or the sleeve lining may be felled to
bottom sleeve without basting.
b. Fell the folded edge of sleeve
Hand
EFc-1
8-10
C
lining to the turnup of the cuff with
or
(b)
(silk)
blind stitching.
301
6-8
0
0
(silk)
(silk)
c. Turn sleeves right side out and
assemble in pairs. Insert a sleeve
pad in the sleeve to avoid creasing
the front and back edges and press
smooth and flat with a heated
pressing machine.
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business