MIL-DTL-29396B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
24 Sew on identification label.
Finished appearance. The
identification label shall be
positioned so that in the finished
jacket, the label shall be midway
between front and back edge of the
left facing, with the bottom edge of
label approximately 4 inches from the
bottom finished edge of jacket.
a. Sew the identification label to
301
SSa-1
10-14
A
A
the outside of the left facing with a
(each
single row of stitches 1/16 inch from
edge)
each edge.
25 Make shoulder straps.
Finished appearance. The piping
shall be uniformly stitched to the
shoulder straps without twists,
gathers, puckers or pleats and shall
be evenly and uniformly worked out to
the edges. The straps shall finish
smooth and flat and shall be uniform
in appearance.
a. The shoulder straps shall be made
of one ply of basic material piped
with white gabardine, polyester and
rayon cloth.
b. Seam a 5/8 inch wide strip of
301
SSe-2
10-14
A
A
white piping to the shoulder straps,
(a)
or
or
along front and back edges and around
A
A
collar end, 1/8 inch from edges.
(silk)
-or-
c. Fold the white piping, slightly
301
SSav-2
10-14
A
A
offsetting the raw edges and seam to
(a)
or
or
edge as above.
A
A
(silk)
d. Turn back the straps and white
301
BSm-2
10-14
A
A
piping, uniformly working the folded
(b)
(silk)
edge of the piping 1/8 inch beyond
the ends of the straps. Topstitch
the straps uniformly 3/16 inch from
the folded edges of piping. Clip the
excess white material at the collar
end so that the strap will lie flat.
e. Press the strap smooth and flat
with a heated pressing iron or
pressing machine.
22
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business