MIL-DTL-29396B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
NOTE: The dressing and shaping of
the left front shall be performed in
the sewing room.
31 Tape armholes.
a. Sew the cotton tape to the
301
SSaa-1
10-14
A
A
armhole starting with one end
approximately 1 inch above the notch
in the fronts and continuing along
the lower and back edge of the
armhole to approximately 1 inch from
shoulder edge.
31 Tape armholes.
(cont'd)
b. The tape shall be stitched with
slight tension along the lower front
edges of the armholes and shall be
held taut while stitching along the
back edge.
32 Press shoulder blades and armhole
tapes.
a. Press the shoulder blades and the
armhole tape smooth and flat with a
heated pressing iron or suitable type
pressing machine.
33 Stitch piping to jacket.
Finished appearance. The piping
shall be uniformly stitched to the
jacket without twists, puckers or
pleats. The piping shall extend from
the collar notch at top edge of the
right front to the collar notch at
top edge of the left front.
a. Position the 1-1/4 inch wide
301
SSa-1
10-14
A
A
strip of piping material on the
outside of left and right front, with
one edge even with top, front and
bottom edges of jacket. Stitch
piping to jacket 1/8 inch from edge.
The piping shall extend from the
collar notch at the top, along the
left and right front and the bottom
edge of the jacket.
25
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business