MIL-DTL-29396B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
26 Assemble fronts.
Finished appearance. All darts and
joining seams shall finish smooth and
flat without pleats, puckers or
gathers. The seams shall start and
finish evenly.
a. The assembly shall consist of
front, side front, side back and
center back.
26 Assemble fronts.
(cont'd)
b. Position the front and side front
interlining on the inside of their
respective front and side front and
fuse (see 3.6.3).
c. Fold the side fronts lengthwise
301
OSf-1
10-14
A
A
with notches matching. Stitch the
entire length of the dart 3/8 inch
from the lower end and tapering to a
point at the upper end.
d. Position the front and side front
301
SSa-1
10-14
A
A
panel with edges even, and join
together with a 3/8 inch seam.
e. Spread open seams and press
smooth and flat with a heated
pressing iron.
f. Press the waist darts flat on the
dart seam without turning the dart to
the right or left.
27 Join backs.
Finished appearance. The side and
center backs shall be joined without
gathers, puckers or pleats.
a. Position the center backs with
301
SSa-1
10-14
A
A
edges even, and join together with a
5/8 inch seam, from the top to the
bottom edge.
b. Join the left and right side
301
SSa-1
10-14
A
A
backs to the respective center backs
with 3/8 inch seam.
23
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business