MIL-DTL-29478A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
Make underarm shields.
8
Finished appearance. The underarm
shields shall finish smooth and flat
without puckers, pleats, gathers, or
other distortions.
a. Bind the rounded edge of shield
301
BSb-1
10-14
A
A
with bias binding, turning under the
outside edge of the binding only, and
catching 1/16 inch from the folded
edge.
b. Press the shields smooth and flat
with a heated pressing iron or
pressing machine.
9
Make cuffs and eyelet opening.
Finished appearance. The cuffs shall
be uniform in appearance, shall
finish smooth and flat, without
twists, gathers, pleats, puckers, or
other distortions. The cuffs shall
finish 5 inches high at the point on
top sleeve and 3 inches high at the
backarm, including piping. The
piping shall be evenly worked out and
shall extend uniformly 1/8 inch
beyond the seamed edges of the sleeve
cuff.
a. The cuffs shall be made of one
ply of the material specified in
3.3.2, piped with the material
specified in 3.3.4.
b. Position one ply of the cuff
301
LSq-2
10-14
A
A
eyelet facing on the outside of
(a)
sleeve cuff, face to face, with the
back edges even and notches matching.
Join the two plies together from
notch to notch with 3/8 inch seam.
c. Extend the depth of the notches
301
LSq-3
10-14
A
A
to the seam line. Turn back the
(b)
facing and top stitch the facing to
the cuff 1/16 to 1/8 inch from the
raised edge.
d. Mark location for three eyelets
on each cuff for removable buttons.
e. Make a 1/8 inch eyelet on each of
Eyelet
22 per
A
A
the marks through both plies.
eyelet
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business