MIL-DTL-29397B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
b. Smoothly fold the free edge of
301
SSa-1
10-14
A
A
the binding over the top edge and to
the underside of the interlining.
Secure the free edge of binding to
the interlining with a row of
stitches 1/8 inch from the raw edge
of the binding.
42 Fell piping to jacket front
interlining.
a. Place the inner edge of piping on
101
the outside of the interlining at the
top, front and bottom edges. Baste
piping to interlining through the
fronts.
42 Fell piping to jacket front
interlining. (cont'd)
b. Fell the front and lower edge of
301
EFc-1
4-6
A
A
the piping to the jacket front
or
interlining.
Hand
C
C
(silk)
c. Tack the raw edge of the bottom
301
SSa-1
4-6
C
C
piping to each seam allowance of
or
(silk)
jacket.
Hand
d. Pull and remove basting stitches
from piping.
43 Join facing to fronts.
a. Position the left and right
fronts to the respective front facing
(face to face), with the notch of the
front in line with the notch on the
facing and with the front piped edge
approximately 3/8 inch from the front
edge of facing. Mark the facing
along the top, front and bottom edges
of jacket.
b. Lap the front edge of the right
301
LSa-1
10-14
A
A
and left fronts, respectively, on the
outside of the facing at the marks
and join the fronts to facing as
close as possible to, but not on top
of, the stitching joining the piping
to the front. The stitching shall
extend from the top to bottom edge of
jacket front edge only and the eyelet
cover shall be caught in the
stitching.
32
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business