MIL-DTL-29397B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
47 Baste linings to jacket.
a. Fold the front lining in
Hand
accordance with the notches forming
or
the chest pleat, and baste along the
301
Hopper
entire center of the pleat. The
folded edge of the pleat on the
outside of the lining shall be
towards the armhole.
47 Baste linings to jacket.
(cont'd)
b. Baste the front lining to the
Hand
jacket, starting at the lower end of
or
the chest pleat, continuing along
301
Hopper
lower edge of armhole approximately 2
inches from the edge and ending at
the side seam. Match side seams of
jacket and lining and continue
basting as close as possible to the
side seam and then across the bottom
towards the front approximately 4
inches from piped bottom edge of
jacket.
48 Baste back lining to jacket.
a. Fold the back lining, forming
Hand
approximately a 1 inch wide pleat at
or
the center back. Baste the back
301
Hopper
lining to the jacket along the center
pleat from the top approximately 3
inches from the bottom finished edge
of jacket.
b. Baste back lining to jacket
Hand
starting at side seam and continuing
or
approximately 3 inches from the
301
Hopper
armhole and shoulder edges, allowing
room for shoulder pad.
c. Turn under the bottom edges of
Hand
front and back lining, and baste
or
along the bottom edge of jacket, with
301
Hopper
the folded edge of lining positioned
approximately 1/2 inch from the
bottom piped edge of jacket.
34
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business