MIL-DTL-29397B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
49 Fell lining to bottom piping.
a. Fell the turned under portion of
301
EFc-1
6-8
0
0
lining along the bottom piping of the
or
(b)
(silk)
jacket with blind stitching 1/4 to
Hand
C
3/8 inch from the bottom folded edge
(silk)
of lining. Only the under ply of the
folded edge of lining shall be caught
in the stitching.
50 Trim lining and interlining.
a. Trim the excess jacket front
interlining and front lining at the
armhole.
b. Trim the back lining even with
the neck.
50 Trim lining to bottom piping.
(cont'd)
c. Trim the shoulder edge of the
front and back lining to
approximately 3/4 inch from shoulder
at the armhole edge and taper the
trimming to 3/8 inch at the neck.
51 Press fronts.
Press each front smooth and flat on a
suitable type heated pressing machine
to conform to the shape of the body
and eliminate excess fullness in the
breast.
52 Make buttonholes.
Finished appearance. The buttonholes
shall be clean cut, well made, well
worked over gimp to fit 40-line
insignia buttons. The gimp and
thread shall be pulled through to the
outside of the front. The purling of
the buttonholes shall be on the
facing side. The inside edge of the
eyelet end of the buttonhole shall be
5/8 inch from the front edge of
jacket. The buttonholes shall be cut
first type.
a. Remove the basting on the
unstitched portion of the braid.
35
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business