MIL-DTL-29478A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
29 Seam reinforcement stay to shoulder
and armhole. (cont'd)
a. Seam the 3/4 inch wide stays to
301
SSaa-1
10-14
A
A
the underside of the front along the
shoulder edges and upper front edge
of the armhole respectively, 1/8 inch
from the outer edges. The strip for
the shoulders shall be positioned
approximately 1/2 inch from neck and
armholes respectively. The strip for
the upper edge of armholes shall be
positioned approximately 1/2 inch
from the shoulder.
30 Mark and dress left front.
a. Mark and dress the left front
edge of coat, from the top notch to
the waist seam. The mark line shall
be 1 inch from the upper front edge
to 1-1/8 inches at the waist seam.
Continue on the straight line, from
the waist seam to the notch at the
bottom of the skirt.
NOTE: The dressing and shaping of
the left front shall be performed in
the sewing room.
31 Tape armholes.
a. Sew the cotton tape to the
301
SSaa-1
10-14
A
A
armhole starting with one end
approximately 1 inch above the notch
in the fronts and continuing along
the lower and back edge of the
armhole to approximately 1/2 inch
from shoulder edge.
b. The tape shall be stitched with
slight tension along the lower front
edges of the armholes and shall be
held taut while stitching along the
back edge.
32 Press shoulder blades and armhole
tapes.
a. Press the shoulder blades and the
armhole tape smooth and flat with a
heated pressing iron or suitable type
pressing machine.
26
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business