MIL-DTL-29478A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
34 Interline fronts.
(cont'd)
b. Baste along the shoulder,
301
Hopper
or
allowing room for setting the
shoulder pad, working the fullness
Hand
toward the armhole. Baste along the
front of the armhole approximately
1-1/2 inches from the edge and
continue to baste down the back edge
of interlining, across the waist
dart, to approximately 2 inches from
the bottom edge of fronts. Baste
along the top edge from the basting
stitches for the shoulders to
approximately 1-1/2 inches from the
front edge. Continue to baste
approximately 1-1/2 inches from the
front edge to the bottom edge of
fronts.
35 Trim coat front interlining.
a. Trim the top edge of coat
interlining even with the top edge of
fronts from the point of shoulder to
the collar notch.
b. Notch the top edge of the
interlining in line with the collar
notch.
c. Remove stitches joining front
edge of polyester and cotton to coat
front interlining, approximately 1/2
inch back from front and top edge of
fronts.
d. Turn the coat inside out and trim
the interlining only approximately
1/4 inch back from the front and top
edge of fronts.
e. Trim the shoulder edge of the
coat front interlining to
approximately 3/4 inch from shoulder
at armhole edge of fronts and taper
the trimming to 3/8 inch at the neck.
28
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business