MIL-DTL-29478A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
40 Baste braid (see Figure 5).
(cont'd)
b. Begin with cut end of braid even
Hand
2-6
C
with straight line at top of harp.
(silk)
Baste the braid along its forward
Black
edge down the center of harp to the
forward edge of harp center.
Continue up the backarm along the
back edge of harp to the straight
line at top using the same edge of
the braid.
c. Baste the bottom edge of braid
Hand
2-6
C
along the straight line to the
(silk)
Black
circle, follow circle back to
straight line and continue to end of
straight line.
d. Repeat steps 40a, b, c, d, e and
f on each, marking on fronts.
41 Tack braid.
a. Securely tack all unattached
Hand
2-6
C
edges of braid to provide a smooth,
(silk)
secure and flat surface of stitching.
Black
b. Tack inside edges of braid
Hand
2-6
C
circles to coat, forming an inner
(silk)
hole approximately 1/4 inch in
Black
diameter.
c. Tack loops at button edge of coat
Hand
2-6
C
together to the coat to finish secure
(silk)
and flat.
Black
42 Stitch braid (see Figure 5).
Finished appearance. All stitching
shall be done 1/16 inch from all
edges whenever possible. All
stitching shall be uniform. All
stitching shall be performed with one
continuous thread whenever possible.
Stitching across braid strands shall
be done only as prescribed or when
absolutely necessary. All edges of
the braid shall be securely attached
to the coat at all points. The braid
and the stitching shall present a
smooth, neat, uniform appearance.
The braid on the right front only
shall be unstitched for approximately
3 inches from front end of the
buttonhole loop braid.
32
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business