MIL-DTL-29478A(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
42 Stitch braid (see Figure 5).
(cont'd)
a. Stitch braid through fronts and
301
SSav-2
10-14
A
A
interlining on both sides of the
(silk)
(silk)
braid 1/16 inch from edge. The line
of stitching shall start and finish
at the harp as shown on Figure 5.
b. Braid may be stitched without
301
SSav-2
10-14
A
A
basting, provided the requirements
(silk)
(silk)
previously mentioned are maintained.
c. Hand stitch the inner edges of
Hand
8-10
C
horizontal braid together on both
(silk)
fronts from harp ends to end of
buttonhole opening on right front and
from harp ends to front end of braid
on left front.
43 Join facing to fronts.
a. Position the left and right
fronts to the respective front facing
(face to face), with the waistline
notch of the front in line with the
notch on the facing and with the
front piped edge approximately 3/8
inch from the front edge of facing.
Mark the facing along the top, front
and bottom edges of coat.
b. Lap the front edge of the right
301
LSa-1
10-14
A
A
and left fronts, respectively on the
outside of the facing at the marks
and join the fronts to facing as
close as possible to, but not on top
of, the stitching joining the piping
to the front. The stitching shall
extend from the top to bottom edge of
coat front edge only.
c. Trim excess facing material where
necessary.
44 Baste front edges.
a. Turn the facing-lining assemblies
to the inside of fronts, completely
working out the corners.
b. Baste along the front edge of
101
left and right fronts, working the
or
facing back from the folded edge of
Hand
piping.
33
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business