MIL-DTL-82125B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
13 Seam front and neck facing to lining;
sew on labels. (cont'd)
b. Join front edge of lining to the
301
SSa-1
10-14
A
A
back edge of facing with a 3/8 inch
seam, turning up the lower end of
facing at the notch for the bottom
turn-up, as indicated by the mark on
patterns, and catching the turned
portion in the seam.
c. Continue to join the top edge of
301
SSa-1
10-14
A
A
the center back lining to the back
edge of neck facing with a 3/8 inch
seam, and with the upper edge of the
size label positioned and caught in
the stitching at the inside center
back pleat.
d. Press the facing and yoke lining
seam smooth and flat with a heated
pressing iron.
e. Sew the identification label to
301
SSa-1
10-14
A
A
the left front facing with a single
(each
row of stitching 1/16 inch from each
edge)
edge of label. The label shall be
positioned vertically with one end
even with the facing-lining seam and
the lower edge approximately 4 inches
above the finished bottom edge of
cape.
14 Assemble back parts.
Finished appearance. Backs shall be
joined without gathers, puckers, or
pleats. The folded edge of the
center pleat on the outside of back
shall be towards the right side.
a. Position backparts with edges
301
SSa-1
10-14
A
A
even and join at the center with a
3/8 inch seam from top to bottom edge
of back.
b. Neatly and evenly pink the seam
allowance of center back 1/8 inch in
depth. When cut on the selvage,
pinking is not required.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business