MIL-DTL-82125B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
2
Replacement of damaged parts.
a. Replace at time of cutting any
part containing damages, such as
holes or seriously weakening defects,
such as smashes, multiple floats, and
slubs likely to develop into holes.
b. Replace any part damaged during
the manufacturing process by needle
chews which may be expected to
develop into a hole, scissors or
knife cuts, tears, holes, mends or
burns.
Shade marking.
3
a. Mark or ticket all component
parts (see 3.6.1.3) cut from one
piece of basic and lining materials
to insure uniform shade and size
throughout the cape.
b. The use of tickets with metal
fastening devices is prohibited on
rayon lining.
4
Make collar.
Finished appearance. The edges of
collar shall be neatly and completely
worked out. The collar shall be
uniform in appearance and the edges
shall be smooth and flat, without
twists, gathers, puckers, or raw
edges (top and sides).
a. The collar and collar stand shall
be made of two plies of basic
material and one ply of interlining.
b. Position the interlining to the
103
SSm-6
4-6
A
under collar and quilt the
interlining and under collar with a
minimum of six rows of blind
stitching. Trim excess interlining
along edges, where necessary.
c. Seam interlining and under collar
301
SSa-1
10-14
A
A
stand together, 1/8 inch from top and
(each
lower edge. Trim excess interlining
edge)
along edges, where necessary.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business