MIL-DTL-82125B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
21 Interline fronts.
a. Position the left and right
301
Hopper
fronts on the respective coat front
or
interlinings and baste along the
Hand
center, distributing the fullness
over the breast area. The basting
shall extend from shoulder edge of
fronts to approximately 1-1/2 inches
from bottom edge.
b. Baste across the shoulder in line
301
Hopper
with the center basting. Continue to
or
baste along the gorge and front edge
Hand
of cape.
c. Bast along the front dart seam
301
Hopper
and continue basting down the back
or
edge of the interlining.
Hand
d. Trim the top corner edge of the
coat front interlining diagonally 1/2
inch.
22 Set collar.
Finished appearance. The collar
shall be carefully joined to the cape
without distortion of the collar
stand or collar.
a. Position collar on outside of
cape with lower edge of collar and
collar stand even with top edge of
fronts and backpart, and with the
collar notch and lower corners of
collar matching.
b. Join collar to fronts and back
301
SSa-1
10-14
A
A
part with a 1/4 inch seam, from
collar notch to collar notch with
center notches matching.
23 Baste facing-lining assembly to
fronts.
a. Position the right and left
301
Hopper
facing-lining assemblies on the
or
outside of the respective fronts and
Hand
baste along the neck, gorge, and
front, continuing the basting along
the bottom edge. The facing shall be
held slightly taut across the bottom
edge of the front while basting.
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business