MIL-DTL-82125B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
14 Assemble backparts.
(cont'd)
c. To form a pleat at center back,
Hand
Hopper
mark the baste on the inside from the
or
top edge down to the bottom in line
301
with the top and bottom notches as
indicated by pattern.
d. Turn the center pleat flat
301
SSa-1
10-14
A
A
against the cape towards the left
side. Secure top and bottom ends of
pleat with a row of stitches 1/8 inch
from the raw edges.
e. Turn the cape to right side and
301
SSa-1
10-14
A
A
topstitch the pleat through all plies
(silk)
(silk)
1-7/8 + 1/8 inches from the folded
edge of pleat (see Figure 2).
f. Press the pleat smooth and flat
from top to bottom edges with a
heated pressing iron or pressing
machine.
15 Tape-arm slit opening.
a. Position the 1/4 inch wide stay
tape to the inside of front and back
part of arm slit opening and with the
edge of tape in line with upper and
lower notches.
b. Stitch the front edge of tape
301
SSaa-1
10-14
A
A
1/16 inch from edge.
16 Join back and fronts at sides.
Finished appearance. The back and
fronts shall be carefully joined at
the sides without twists, gathers,
puckers, or pleats. Seams shall
start and finish evenly.
a. Position the back and fronts with
301
SSa-1
10-14
A
A
edges even and join together at the
sides with a 3/4 inch seam, leaving
an opening for arm slit from notch to
notch.
b. Spread open side seams, including
arm slit opening and press flat with
a heated pressing iron.
c. Neatly and evenly pink the side
seam allowance 1/8 inch in depth.
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business